Pressure drop in psi (pounds per square inch) per 10 feet of hose (smooth bore) without fittings. Fluid specification: Specific gravity = 0.85; Viscosity = v = 20 centistokes (C.S.), (20 C.S. = 97 S.S.U.) Pressure drop values listed are typical of many petroleum based hydraulic oils at approximately +100ºF (+38ºC).

EN 853 1SN High Pressure Hydraulic Rubber Hose. Construction. Tube: high quality synthetic rubber compounds. Reinforcement: one-braid high tensile steel wire. Cover: abrasion and

Below you will find the impressive specifications of our 1 wire and 2 wire steel braided hydraulic hoses. In the toughest of environments our choice of hose reigns supreme and you can see why. 1 wire braided hose – FLEXOR 1SN/R1AT ISO 1436-1 – SAE 100 R1AT EN 853 1SN Tube: oil resistant synthetic rubber. Reinforcement: one high tensile steel braid.

R15 Hydraulic Hose R14 -R14 Stainless Steel PTFE Hose R5 - Textile Cover Hydraulic Hose Using our in-house hydraulic hose crimpers, we can produce hoses up to 2" in diameter with bite to the wire hose end fittings. Contact us today with your specifications and we would be able to produce and ship your hose order within the same week.

This hose shall consist of a thermoplastic inner tube resistant to hydraulic fluids with suitable synthetic fiber reinforcement, and a hydraulic fluid and weather resistant thermoplastic cover. Specification: Metric Size SAE Dash Size ID Min ID Max OD Max Max Working Pressure MPa Min Bend Radius 3.2 -2 3.4 4.0 9.5 21 25 5 -3 4.6 5.4 11.4 21 90

Online supplier of hydraulic hoses, hydraulic fittings, fitting adapters and hose fittings. Shop online and save on all of your hydraulic components. Contact Us 11795 E 45th Ave, Denver, CO 80239 Denver, CO 80239 Phone : (303) 945-9080 Email : [email protected]

All Balflex® hydraulic hoses are produced to Balflex® specifications and according to ISO 1436, SAE J517 and EN 853 to EN 857 standards. They cover a wide variety of low to very high pressure applications, in rubber, thermoplastic or P.T.F.E, with textile and steel reinforcement, for petroleum and water base hydraulic fluids.

A hydraulic hose assembly custom made for your business from Hydraulics Center will use hoses and construction methods specified for the type of work the assemblies will be subjected to. We use only the best materials and pressure test each assembly before the sale. Fittings are crimped onto the ends of the hoses without compromising the

Hydraulic hose specification SAE 100R6. Series - SAE100R6PM No filters selected 1/2 1/4 3/4 Hydraulic hose specification SAE 100R6. Series - SAE100R6PM Where to Buy SAE100R6PM hose is made as per the specification SAE type 100 R6. Hose reinforcement is synthetic textile braid and recommended for using on low pressure and return lines.

Hydraulic hoses meeting ISO 18752 specifications are classified according to their resistance to impulse pressure in four grades: A, B, C, and D. Each grade requires a specific number of impulse cycles at a certain temperature and impulse pressure in order to meet the standard.

Hydraulic Hose End Crimp Specifications. (303) 945-9080 M-F: 7a-5p MST. Crimp Specifications. Machining tolerances exist for each crimper, die set and supporting piece of equipment which will affect your actual setting. Always check the crimp diameter to ensure that it is within the published limits. Using a caliper make two measurement in