2. SLING ANGLE. eye bolt capacity chart · 3. CONNECTIONS. The third factor to consider when selecting the correct eye bolt for a lift is to take 

downguys at bolt hole 73) - See plate GY7SPL. Provisions for downguys are also provided on the steel crossarm and the 3-phase cutout and arrester bracket if required. E. GUY ANCHORS Two basic types of anchoring systems are used for downguys -- one is the screw type and the other is the "Manta-Ray" type.

Metric bolts are referenced using "M" sizes, such as the M8 bolt size. The size of a metric bolt is specified using pitch, diameter, and length in millimeters. For example, in M8-1.0*20, the "M" means the Metric thread designation, the digit 8 refers to the Nominal diameter (in millimeters), 1.0 refers to the pitch, and 20 refers to the

and charts below before using eye bolt assemblies. Table 2 (in-Line) Metric Size Working Load Limit - kg m6 200 m8 400 m10 640 m12 1000 m16 1800 m20 2500 † Always apply load to eye bolt in the plane of the eye - not at an angle. † Never exceed the capacity of the eye bolt-see Table I & 2. † When using lifting slings of two or more

case of multi-leg slings the specified angle or range of angles. (2) When using slings in choke hitch multiply the marked SWL by 0.8 to obtain the reduced maximum load the sling may lift ie reduce the safe working load by 20%. (3) With multi-leg slings, when using less than the full number of legs, reduce the maximum load in proportion to the

PLATED MACHINERY EYE BOLTS ZINC PLATED HOT GALVANIZED PLAIN PATTERN – ZINC SHOULDER PATTERN – ZINC PLAIN PATTERN – GALVANIZED SHOULDER PATTERN – GALVANIZED M a d e i n U S A Plain Pattern No. Bolt Diameter N.C. Standard Shank Length Part No. Weight Per 100 11/4" 1"26005 3 5 2 5/16" 1-1/8" 26008 4 10 3 3/8" 1-1/4" 26011 4 15.5

Regular Nut Eye Bolt Shoulder Nut Eye Bolt Machinery Eye Bolt G-291 G-277 G-279 Important Safety Information— Read and Follow Inspection/Maintenance Safety: † Always inspect eye bolt before use. † Never use eye bolt that shows signs of wear or damage. † Never use eye bolt if eye or shank is bent or elongated.

WORKING. LOAD. SINGLE EYEBOLT. AXIAL. MAXIMUM LOAD (W) TO BE LIFTED BY A. PAIR OF EYEBOLTS WHEN THE ANGLE. BETWEEN SLING LEGS IS:.

Eye Bolt Sizes; Eye Bolt Lifting Capacity Chart. What are Eye Bolts? The eye bolt (otherwise known as a lifting eye 

For angle loading, see page 200. S-279 UNC Shoulder Type Machinery Eye Bolts diagrams and charts below before using eye bolt assemblies.

Observe working load limitations (be especially careful with eyebolts used for angle lifts - see sling angle chart). 2. Visually inspect hoist ring prior to use. 3. Fully tighten hoist ring to recommended torque. Full thread engagement is required (no space between swivel bushing and lift). 4. Assure proper thread depth - do not shim. 5.