Minimum spacing of the SDS for LVL and LSL applications is 6" o.c., minimum end distance is 6", and minimum edge distance is 5/8". Wood structural panel up to 1 1/8" thick is permitted between the sole plate and rim board provided it is fastened to the rim board per code and the minimum penetration of the screw into the rim board is met.

copper-alloy casting to crushers structural screw spacing ledger board jaw crusher parts c120 roller crusher working principle jaw crusher brochure. Impact Crusher - Impact Crusher Suppliers, Buyers.

1/28 · If the studs are framed at 16 inches on-center, a 20-foot ledger would cross 14 studs, so the next step is to divide 6,000 pounds by 14. The resulting load per stud is 429 pounds.

The International Residential Code lists two fasteners for directly attaching ledgers to a house: 1/2-inch-diameter hot-dip-galvanized 

8/6 · SPAX® Deck Screws Perfect for Ledger Board Installation Still looking to add that outdoor space to your backyard this summer? Or maybe you're a professional contractor that

2) Spacing based on linear interpolation of spacing table in Appendix AM104.1 of North Carolina Building Code. 3) Rim board shall have a minimum thickness of 1-1/8". 4) A maximum 1/2" wood structural panel may be installed between the deck ledger and the rim board. 5) Ledger board shall be designed according North Carolina Building Code

2x deck ledger shown. (double 2x ledger similar). SDWS wood screws stagger vertically spaced in accordance with table. Rim board per table. Wood structural.

www.strongtie.com. SDWS TIMBER Screw. Structural Wood-to-Wood Connections Including Ledgers above also provides SDWS screw spacing for a wider range.

LedgerLOK is a code-compliant structural wood screw engineered to fasten a deck ledger board to the rim joist of a house with no predrilling. No Pre-Drilling Required: Installs in a fraction of the

4/17 · Structural deck ledger screws (left) are easier to install than 1/2-in. diameter galvanized lag screws (above), because pre-drilled holes aren't required. But they must be

Typically, you will need to install your bolts alternating high and low 2" from the top and bottom of the ledger board. As a rule of thumb, bolts can be spaced 16" on center for supporting joist