Measure electrical contact between slip ring and shaft at least monthly to reveal any concealed corrosion. If resistance exceeds 5 mΩ: Overhaul the slip ring. • 

via a sliding contact to the wheel set shaft, Our earthing contacts o er good protection equipment companies in the world with more.

Required equipment to comply: • BWCM System. • Water in Oil sensor. • Shaft Earthing Device. • Computerised Planned Maintenance System.

The Propeller Shaft Grounding (PSG) system is installed on propeller shafts to insure a path of low resistance. Protecting your precious equipment.

800 series available with AEGISTM shaft grounding rings. The encoder need to be pre-prepared with a special encoder shaft in order to permit the mounting of a SGR. As the SGR is somewhat subject to wear are they always mounted outside the encoders enclosure [Figure 5] and can therefore easily be replaced. Thus preventing cur-

SHaft Earthing DEVICE - Read online for free. Open navigation menu

To protect the bearings from harmful currents the bearings are electrically insulated and the shaft equipped with an earthing device. The earthing devices that are normally used are based on metal to metal contact which requires a lot of maintenance, or based on micro-fibers which are costly and restricted by export control regulations.

A lifting beam, jib and tackle are provided, as well as the rotor turning device, to ensure operator safety when removing, PDF Parts with Equipment. 4600114 toro 150e scoop toro 151d scoop 09370189 o-ring. 2. 9370189 toro 150e scoop 64255848 parts kit,seal,replmt,cyl,lift. 2.

corrosion, passive shaft-grounding devices use conductive materials force (EMF)-induced current; and Ic is the shaft earthing devices.

Furthermore, because the grounding brushes also are the coupling point of rotor earth fault protection, reduced grounding functionality can cause false earth 

For IOM information of associated equipment supplied by VAF Instruments, refer to the separate manual supplied with those products.